Peugeot 308 Key Fob Replacement
Peugeot's 308 might be slightly old, but it is still attractive. It might not be the most luxurious car in its class It's it's a Ford Focus or Volkswagen Golf will isolate you even better from sloping surfaces - but it's a relaxing and civilised drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. No matter if the issue is ongoing or continuous, the following tips should aid.
Water Damage
If you leave your fob in a puddle or get it wet while kayaking, swimming canoeing, rafting, or canyoning, it's most likely to be damaged by water. Keep your key fob in a dry bag whenever you go outside or engage in activities that expose it to excessive amounts water.
It is also important to make sure that the fob is completely dry before opening it up and reusing it. If you notice any odors emanating from the fob like an industrial-like smell or a sour taste like windshield washer fluid, this is another indication that it's been submerged in water.
A wet circuit board can cause the battery to dump its energy or even explode. If you're able to fish the 308 key fob of the water body it was stuck in turn the button upside down and shake out as much water as possible before opening the case. Remove the battery, then clean the circuit board using a cotton swab that has been dipped into 90-percent alcohol.
Other causes why your Peugeot 308 remote entry keyless system might not work include a dead coin-cell battery, receiver module problems signal interference, or a malfunctioning chip. If none of these are the reason, you may try resetting the system by disconnection of the battery with 12 volts for approximately 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with a remote-start system that allows the driver to start the car from afar and then warm up or cool down the vehicle prior to stepping inside. This feature is extremely helpful particularly during the cold winter months. The remote start system can not function due to a variety of reasons, including a dead coin-battery.
A coin-shaped battery located inside the key fob has a lifespan of between two and four years, based on how frequently it is used and where it is purchased. The date of use is displayed on the packaging or in the user manual.
If the key fob is no longer working after being exposed clean tapwater, remove the battery and clean the electronic chip using a paper towel soaked in isopropyl ethanol. Then dry the chip thoroughly before replacing it. If you expose it to soapy or salty water, the chip may be fried and you will need to replace the key fob completely.
If you're unsure if the battery is in good condition you can check its voltage using a multimeter set to the vehicle's voltage range and connected to the terminals for minus and plus. The voltage should be between 12 to 13 volts, but if it is lower, the battery must be replaced. You can also reset the computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should be able to start after this.
Faulty Receiver Module
If you're not getting the "Key Detected" message on your dashboard, it's possible the receiver module has created a fault. It's the part that transmits an alert when your key fob goes off. It also acts as an alarm that stops the car from starting if you don't have the correct key.
This could result from a variety of causes, such as water damage or simply the aging process. If your Peugeot 308 key fob has been exposed to dirty tap water, as in the chip that is located on the inside will be damaged. In this situation you'll need to remove it apart and thoroughly clean it with isopropyl alcohol or an electronic cleaner. Once the battery has dried, you can try again.
If the issue persists then it's a good idea to see an area Peugeot specialist or locksmith. They can employ a diagnostic tool in order to identify the issue and fix it.
The loss of your Peugeot car keys could be an extremely stressful experience. However, a qualified auto locksmith can address the issue in a matter of minutes. They can program your vehicle and cut a fresh, functioning key for you. Click here to find a locksmith near you.
Faulty Electronic Chip
The chip in the Peugeot 308 key fob plays a crucial function in the remote control system. If the chip is damaged, you could encounter issues starting your car or get a message saying "anti-theft". In this scenario, the only solution is to replace the key. Auto locksmiths who are professionals are able to provide the service in the shortest time.
The chip in the chip of your Peugeot 308 key fob can become faulty due to sweat, water damage dirt, or other causes. If your Peugeot 308 key fob has been exposed to soapy water, you should take it to the cleaners immediately. You can wipe the electronic component using paper towels soaked with isopropyl Alcohol. The battery should be allowed to completely dry.
Radio interference can cause the key fob to stop functioning. This can be caused when other devices operate on the same frequency as your Peugeot keyfob. This can be caused by problems with the environment or objects within the vicinity of the vehicle. It is recommended to visit a Peugeot dealer if you experience this problem.
The Peugeot Key Fob 207/308 is very delicate and requires special care. peugeot car keys g28carkeys.co.uk should not be dropped or throw it around. If you lose something, try to locate it as soon as you are able to. You can reset all the on-board computers by disconnecting the 12 volt battery for a few minutes. Be sure to disconnect the negative cable first, then the positive.